Filter
Top Products
Install properly...
Remove sales labels...
Remove the Consumer Buy Guide label and any
inside labels before using the freezer.
To remove any remaining glue:
1 Rub briskly with thumb to make a ball, then
remove.
OR
1 Check the strength of the floor It should hold the
weight of a fully loaded
freezer
2 Pick a safe place, indoors, away from in-
flammables such as gasoline.
3. Allow at least 3 inches (7.5 cm] air space on all
sides of freezer and 2 inches (5 cm] at back Leave
room at top for lid to open all the way.
4. It should not be necessary to remove the lid during
installation. If, for any reason, the hinges need ad-
justment, see your authorized WHIRLPOOL dealer
5. Do not cover the freezer wlth Items such as
blankets, sheets, tablecloths, etc.
Level chest freezer.. .
from end to end and front to back so that the IId will
seal properly.
Check with level
Install defrost drain cover...
1 Remove cover from literature package.
2 Check drawing on front cover for placement
3. Install cover.
2 Soak area with dlshwashlng detergent solutlon (1
teaspoon detergent in 1 quart warm water) be-
fore removing glue as described In step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Care 6 Service label
on lnslde Ild or Tech Sheet on back of cabinet.
Clean it . . .
Clean vour freezer before
using It See cleaning
Instructions on page
6
Plug it in...
3-prong grounding
type wall receptacle
Retaining Clip
Freezer /
Power Plug
” ‘T” grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is required.
It is recommended that a separate circuit serving only
this appliance be provided. Use a receptacle
which cannot be turned off with a switch or pull
chain. Do not use an extension cord.
Attach retaining clip over power cord plug from
literature package inside the freezer
4