Filter
Top Products
Install properly..
l&l
I
Allow room to open lid
w
2 Inches at back
, 80
1 Check the s,rength of the floor it
ShOLi’C! ““iti
the
weight of a My loaded freezer
2 Pick a safe place, indoors, away from in-
flammables such as gasoline.
3. Allow at least 3 Inches (7 5 cm) air space on all
sides of freezer and 2 Inches (5 cm] at bock Leave
room at top for Ild to open all the way
4 It should not be necessary to remove the IId during
installatron. If. for any reason, the hinges need ad-
justment, see your authorized WHIRLPOOL dealer,
5. Do not cover the freezer with items such as
blankets, sheets, tablecloths, etc.
Level chest freezer.. .
from end to end and front to back so that the lid WIII
seal properly
Check with level
y
Install defrost drain cover...
1. Remove cover from literature package.
2 Check drawing on page 2 for placement.
3. Install cover.
Remove sales labels...
Remove any labels before using the freezer.
To remove any remaining glue:
1. Rub briskly with thumb to make a ball, then remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachlorlde, etc. These can damage the
materlal.
NOTE: DO NOT REMOVE the Tech Sheet on inside
of compressor compartment door.
Clean it . . .
Clean your freezer before
using it See cleaning
InstructIons on page
6
Plug it in...
3-prong grounding
type wall receptacle
Freezer
Power Plu
3-piong
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is required.
It is recommended that a separate circuit serving
only this appliance be provided. Use a receptacle
which cannot be turned off with a switch or pull
chain. Do not use an extension cord.
See individual electrical requirementsand ground-
ing instruction sheet in your literature package
4