Filter
Top Products
Changing the light bulbs...
Removing the base grille...
To
remove the grille:
r
METAL CLIPS
7
1. Open the door
2. Pull grille outwards as shown.
3. Do not remove Tech Sheet fastened behind
grille.
Ice cube trays...
If cubes are noT used,they may shrink The mov-
Ing cold air starts a slow evaporation. The longer
cubes are stored, the smaller they get.
Optional automatic ice maker.. .
If you have the automatic ice maker accessory
or if you plan to add one later (Part No. ECKMF-831,
there are a few things you will want to know,
l
The ON/OFF lever IS a wire signal arm
Down...for making ice automatically
Up...to shut off the ice maker.
DO NOT TURN ICE MAKER ON UNTIL IT IS CON-
NECTED TO THE WATER SUPPLY.
l
The dial or lever on the side of the !ce maker
changes the stze of the cubes.
l
Shake the bin occasionally to keep cuDes sepa-
rated, and to obtain increased storage capacity.
l
It IS normal for ice crescents to be attached by a
corner. Thev will break aDart easily
* You will hear water running when ice maker IS
working. You’ll hear ice fall into the bin Don’t let
+?ese sounds bother vcu
To replace the grille:
1. Line up grille support tabs with metal clips.
2. Push firmly to snap into place.
3. Close the door.
r ~~~~~b,th ends.
2. Slightly twist.
The ice maker will not operate until the freezer
is cold enough to make ice. This can take
overnight.
Because of new plumbing connections, the first
ice may be discolored or off-flavored. Discard
the first few batches of ice.
If ice is not being made fast enough and more
ice is needed, turn the Refrigerator Control to-
ward a higher number. Wait a day and, if neces-
sary, turn the Freezer Control toward A.
If you remove the ice bin, raise the signal arm to
shut off the ice maker. When you return the bin,
push it all the way in and lower the arm to the ON
position.
If cubes are stored too long, they may develop
an off-flavor...like stale water. Throw them away.
They will be replaced. Cubes in the ice bin can
also become smaller by evaporation.
Good water quality is important for good ice
quality. It is not recommended thatthe ice maker
be connected to a softened water supply. Water
softener chemicals such as salt from a malfunc-
tioning softener can damage the ice maker
mold and lead to poor quality ice. If a softened
water supply cannot be avoided, then it is impor-
tant that the water softener be well maintained
2nd operating properly
7