Filter
Top Products
Changing the light bulbs...
WARNING: Before removing a light bulb, either unplug the refrigerator or disconnect the electricity
leading to the refrigerator at the main power supply. Shock and injury can occur if
electricity remains connected.
Ice Compartment Door...
1. Reach behind the control console to find bulbs
2. Remove bulb.
3. Replace with a 40-watt appliance bulb.
Ice cube trays...
(Model ET22MK only)
If cubes are not used, they may shrink The moving
cold air starts a slow evaporation. The longer cubes
are stored, the smaller they get.
Pull the Ice compartment door panel out from the
bottom and slide it to the rear
To remove ice:
1 Hold troy at both ends
2 Slightly tw:st
Automatic ice maker.. .
l
You WIII hear water running when ice maker IS
If you have Model ET22MM and have the auto-
working You’ll hear ice fall into the bin Don’t let
matic ice maker accessory, or If you have Model
these sounds bother you
ET22MK and plan to add one later (Part No
l
The Ice maker ~111 not operate until the freezer IS
ECKMF-83). there are a few things you will want to
cold enough to make ice This con take overnlght.
know:
l
Because of new plumbing ccnnectlons, the first
l
The ON OFF lever
IS a
wire slgnal arm
Ice may be dIscolored or off-flavored Dlscard the
Down .for making Ice automatically
first few batches of Ice
Up. to shut off the Ice maker
l
If ice IS not betng made fast enough and more Ice
l
Shake the bin occaslonally to keep cubes sepa-
IS needed, turn the Refrigerator Control toward a
rated, and to obtain Increased storage capacity
higher number Walt a day and, if necessary, turn
l
It IS normal for rce crescents to be attached by a
the Freezer Control toward A
corner They
WIII
break apart easily
l
If you remove the ice bin, raise the slgnal arm to
shut off the Ice maker When you return the bin,
On
push it all the way In and lower the arm to the ON
posltlon
Arm to Start It.
l
If cubes are stored too long, they may develop an
off-flavor
like stole water. Throw them away They
WIII be replaced. Cubes In the Ice bin can also
become smaller by evaporation
l
Good wafer quality IS important for good Ice quality
It IS not recommended that the Ice maker be con-
nected to a softened water supply Water softener
chemicals such as salt from a malfunctioning sofi-
Raise Signal
ener con damage the Ice maker mold and lead to
Arm to Stop Ice Maker
poor quality Ice If a softened water supply cannot
be avoided. then It IS Important that the water soft-
ener be well molr>+alned and operatlrg properly
7