Filter
Top Products
Install properly.. .
-I I.
3 inches
I
1. Allow 3 Inches (7.5 cm] between overhead cab-
inets and the refrigerator top.
2. Allow at least on inch (2.5cm) between the refrig-
erator condenser and the wall
3. Allow 112 inch (1.25 cm] on each side of the re-
frigerator for ease of installation
4. If the refrigerator is to be against a wall. you might
wont to leave enough space so the door con be
opened wider.
,..
:. i
Level refrigerator-freezer...
This refrigerator has 2 threaded levelling legs that ore
shipped in a separate package.
1 Screw these legs all the way into bolt holes in the
bottom front corners of refrigerator.
2. Roll the refrigerator into place.
3. Lower legs just enough to lift front rollers off floor.
4. Adjust front legs to level the refrigerator.
-
To raise corners, turn legs counterclockwise.
-
To lower corners, turn legs clockwise.
5. Check with level
Remove sales labels.. .
Remove the Consumer Buy Guide label. tape and
any inside labels before using the refrigerator
To remove any remaining glue:
1 Rub briskly with thumb to make a ball then remove
OR
2 Soak area wtth dlshwashing detergent solution (1
teaspoon detergent in 1 quart worm water) before
removing glue as described In step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it.. .
Clean your refrigerator
before using it See clean-
ing InstructIons on pages
7
and 8
Plug it in...
grounding type
wall receptacle
t
grounding plug
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz.. AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired It IS recommended that a separate circuit
serving only this appliance be provided.
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain. See indlvldual electrical require-
ments and grounding instruction sheet in your liter-
ature package
4