Filter
Top Products
Install properly.. .
Remove sales labels.. .
.
Remove the Consumer Buy Gurde label, tape and
any
inslde
labels before using the refrigerator.
To remove any remaining glue:
I, Rub briskly with thumb to make a ball then remove.
OR
1. Allow 3 inches (7 5 cm) between overhead cabr-
nets and refrrgerator top.
2 Allow at least an inch (2 5 cm) between the
refrigerator condenser on the back and the wall
3
Allow ‘/2 Inch (1.25 cm) on each side of the
refrigerator for ease of Installation.
4 If the refrigerator IS to be agarnst a wall, you might
want to leave extra space on the hrnge side so the
door can be opened wider.
Level refrigerator-freezer.. .
Leveling screw
Rdlse 1
Right to Raise;
Use Screwdriver
to Adjust
Left to Lower
1 To raise front, turn each screw to the right
2 To lower front, turn each screw to the left
3 Check with level
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetmchloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it.. .
Clean your refrigerator
before using it.
See cleaning instructions
on page 8
.I”-- I .I_.,--L.x~I .s--7w-.
Plug it in...
J-prong grounding
type wall receptacle,
Rsfrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply IS re-
quired It is recommended that a separate circuit
serving only this appliance be provided
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain.
See individual electrical require-
ments and grounding instruction sheet in your liter-
ature package.
4