Filter
Top Products
Install properly..
Remove sales labels...
Remove any labels before usrng the freezer
To remove any remaining glue:
1 Rub brrskly with thumb to make a ball then
remove
OR
2 Soak area with drshwashlng detergent solutron (1
teaspoon detergent In 1 quart warm water] be-
fore removing glue as descrrbed in step 1
DO NOT USE rubbing alcohol or tlammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Tech Sheet on the
back of the cabinet.
2
Inches
II
Ii
0 0
1. Check the strength of the floor It should hold the
weight of a fully loaded freezer
2-inch spacer
2 Pick a safe place, indoors, away from inflam-
mables such as gasoline.
3. Spacers are packed In the freezer. Install them as
shown to keep freezer at least 2 inches (5 cm) from
the wall
4 Remove the shrpprng block.
5. Allow at least 3 inches (7 5 cm] air space on top
and each side of the freezer
6 Do not cover the freezer with Items such as
blankets, sheets, tablecloths, etc
Level freezer...
I. Slide freezer into place.
2 Level freezer using wood shims so that door will stay
open at any position.
4
Clean
it . . .
Clean your freezer before
using it See cleanrng
InstructIons on page 6
Plug it in...
3-prong groul nding
type wall receptacle
Retaining Clip
Freezer 1
Power Plug
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided. Use a
receptacle which cannot be turned off with a
switch or pull chain. Do not use an extension
cord. See individual “Electrical Requirements and
Grounding Instructions” provided with your
product.
Attach retaining clip over power cord plug from
literature package inside the freezer.