Filter
Top Products
Changing the light bulb...
Light Shield
Removing the bottom trivet...
To remove:
I. Lift front of trivet out of supports.
2 Pull out.
Lift the Front,
Then Pyll Out
To replace:
1 Position back of trivet on the rear wall supports.
2 Lower front into place.
Energy saving tips...
You can help your freezer use less electrtcity
l
Set Temperature Control to provide temperatures
l
Check door gasket and level freezer to assure a
around 0°F ( ~ 17.8 “C) There is no need to store
good door seal.
foods below 0°F
l
Clean the condenser coils regularly
l
Keep door openings to a minimum Remove several
items at one time. Keep contents organized to elimi-
nate searchrng.
l
Fill to capacity Follow recommended procedures
for freezing foods See pages 8 and 9.
l
Keep door locked to ensure door closure.
l
Do not let frost build up to more than ‘/4 inch (6 mm]
thick Efficiency is reduced.
l
Keep Power Saving Control on OFF when humidity is
low
WARNING: To avold possible shocks, tlrst unplug
treezer or turn off electrlclty leadlng
to freezer at the maln power supply.
I, Remove the light shield from the side of the control
panel. Depress the back of the shield to release the
tabs, then pull
away
2. Replace bulb with a 40.watt appliance bulb.
3. Replace the light shield. Insert the shield tabs in the
slots, then press the shield to snap into place.
4. Plug in power cord or switch on electricity
6