Filter
Top Products
Install properly...
& n
3 Inches
A
1 Check the strength of the floor It should hold the
weight of a fully loaded freezer
2 Pick a safe place, indoors, away from in-
flammables such as gasoline.
3
Allow 3 Inches, 7 5 cm) olr space on top of freezer
for proper ventMotion
4 Allow at leas’ on Inch (2 5 cm] Detweer the
freezer condeclser on the bock of the unit and
the wall
5 Allow II, Inch [” 25 cm) on each side of the freezer
for ease of insi .~llation
6 If the freezer II to be against a wall, yod might
want to leave extra space on the hinge side so the
door can be coened wider
Level freezer...
Raise
Start adjustment with the door hinge side.
1 Slide freezer InI3 place
2 Adjust front legs to level the freezer
To raise front, lurrl each leg clockwIse
To lower front turc each leg counTer-clockwise
3 Check with level
4 After freezer
IS
f 1lly loaded recheck with level
Remove sales labels...
Remove the Consumer Buy Guide label and any
inside labels before using the freezer
To remove any remaining glue:
1 Rub briskly with thumb to make a ball, then
remove
OR
2 Soak area with dlshwashing detergent solution (1
teaspoon detergent In 1 quart worm water) bo-
fore removing glue as described In step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Tech Sheet fas-
tened under the freezer at the front.
Clean
it . . .
Clean your freezer before
using it See clearrlng
instructIons on page 7
Plug it in...
J-prong groundir
type wall receptacle
Retainipg Clip
Freezer
/
Power Plug
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrlcal supply is required.
It IS recommended that a separate circuit serving only
this appliance be provided. Use a receptacle
which cannot be turned off with a switch or pull
chain. Do not use an extension cord.
A
Attach retaining clip over power cord plug from
literature package Inside the freezer.