Filter
Top Products
Install properly... Remove sales labels...
1 Check the strength of the floor It should hold the
werght of a fully loaded freezer
2 Pick a safe place, indoors, away from in-
flammables such as gasoline.
3 Allow 3 Inches (7 5 cm] air space on top of freezer
for proper ventilation
4 Allow at least an Inch (2 5 cm] betweer the
freezer conaenser, on the back of the unit. and
the wall
5 Allow ‘: inch (1 25 cm) on each side of the freezer
for ease of ir stallation
6 If the freezer IS to be against a wall you might
want to leave extra space on the hinge side so the
door can be opened wider
Level freezer...
so the door will stay open at any position
Raise
Lower
This freezer has 2 threaded leveling legs that are
shipped in a separate package.
4. Screw these legs all the way into bolt holes in the
bottom front corners of the freezer
2. Slide the freezer into place.
3. Adjust front legs to level the freezer.
-To raise front, turn legs clockwise.
~ To lower front, turn legs counterclockwise.
4. Check with level.
5. After freezer is fully loaded, recheck wtth level.
Remove the Consumer Buy Guide label and any
inside labels before ustng the freezer
To remove any remaining glue:
1 Rub briskly with thumb to make a ball, then
remove
OR
2 Soak area with drshwashing detergent solution [I
teaspoon detergent in 1 quart warm water] be-
fore removing glue as described In step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Tech Sheet fas-
tened under the freezer at the front.
Clean it . . .
Clean your freezer before
using It See cleaning
InstructIons on page 7
Plug it in...
3-prong groundin
type wall recepta
RetainiFg Clip
Freezer ’
Power Plug
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is required.
It is recommended that a separate circuit serving only
this appliance be provided. Use a receptacle
which cannot be turned off with
a
switch or pull
chain. Do not use an extenslon cord.
Attach retaining clip over power cord plug from
literature package inside the freezer.