Filter
Top Products
2 Insert Dasket Inlo wall suppons one siae aT a Time
Removing the bottom basket . . .
To remove:
1. Lift front of basket up to remove from wall supports.
2. Pull out
To replace:
1 Positlon basket in bottom of freezer.
^. ,,I ,,
.I / /
Adjusting the freezer shelf...
To remove shelf:
1 Remove food from shelf
2 Slide shelf straight out to stop
3
Lift
front
Guide Stop
4 Slide the rest of the wav out
Shelf Stop
To replace shelf:
1
Fit back of shelf on top of gulaes with wire stops on
bottom of guides.
2 Loft front, then slide shelf until It clears the guide
stops
The key eject lock...
can help reduce the hazard of child
entraorrent
The signal light...
automatically warns of any unexpected
power failure
SIgnal Llghl
If the signal light is not glowing, immediately check,
l
for power Interruption,
l
for an unplugged power cord,
l
for a burned out signal light.
Energy saving tips...
You can help your freezer use less electricity
l
Check door gasket and level freezer to assure a
good door seal
l
Clean the condenser
coils
regularly
l
Keep door openings to a mlnlmum. Remove several
Items at one time Keep contents organized to ellml-
note searching
l
Fill
to capacib Follow recommended pror 2dures
for freezing foods See pages 8 and 9
6
To lock or unlock the freezer you must hold the
Key ~rl the lock while turning The lock
IS
spring
loaded so the key cannot be left
or
the lock
If the key
IS
lost. contact your WHIRLPOOL
dealer for a replacement Always give the com-
plete model and serial number of your freezer
when requesting a replacement key
To replace burned out signal light:
1 Unplug power cord from outlet
2 Open the freezer door
3 Push out signal light from behind, then unplug
burned out light. Replace light with one of
the same wattage and size Signal light can
be ordered from your WHIRLPOOL dealer,
Part No. 1103639
4. Close freezer door and plug power cord into
outlet.
l
Set Temperature Control to provide temperatures
around 0 F [
17 8 C) There IS no need to store
foods below 0 F
l
Keep door locked to ensure door closure
l
Do not let frost build up to more than !‘3 inch (6 mm)
thick Efftclency
IS
reduced
l
Keep Power Saving Control on OFF when humldlty is
low