Filter
Top Products
Using your freezer
Setting the temperature control...
To start, turn control to the middle of the doI Thus
setting IS designed to marntain the temperature at
0’ near 0 F[
‘7 8 C) under normal operating
; ondrtrons
The Power Saving Control...
Joerates electric heaters These heaters help pre-
.~~r~* moisture frc’m formrng on the outside of the
fr:,ezer when hurjldrty
IS
high
’ Jse the 3FF setting when humidity E iow
L .>se the C)N setting only If morsture forms on the
>Jslde of the freezer
Changing the light
bulb...
Adjusting the basket shelf...
To remove basket shelf:
1 Remove food from basket
2 Slide basket straight out to stop
3 Lift front
4 Slide the rest of the way out
To replace basket shelf:
1 Fit back of basket shelf on top of guide stops on
bottom of gurdes.
2 Lrft front, then slide the basket until it clears the
guide stops.
Adjusting the temperature control..,
1 Turn control to hrgher number for colder temper-
atures
2 Turn to lower number for less cold temperatures
Cooling freezer first...
1 Allow freezerto cool 6 to 8 hours before hlling with
frozen food.
2 Let It cool overnight before adding large amount
of unfrozen food.
Note: When freezer IS first started, the compressor
vii111
run constantly until the cabinet
IS
cooled It may
take up to 6 to 8 hours or longer, depending on room
temperature and the number of times the freezer
door 1s opened
After the cabinet IS cooled, the compressor
will
turr ON and OFF as needed to keep the freezer at
the proper temperature
WARNING: To avold posslble shocks, first unplug
freezer or turn off electrlclty leadlng
to freezer at the maln power supply.
1 Remove the light shield from the side of the control
panel Depress the back of the shreld to release the
tabs, then pull away
2 Replace bulb wrth a 40-w&t applrance bulb
3 Replace the lrght shield Insert the shield tabs in the
slots, then press the shield to snap into place