Filter
Top Products
Using your freezer
Setting the temperature control...
To start, turn control to the middle of the dial Thus
setting IS designed to morntarn the temperature at
or near 0°F [ 178 C) under normal operating
conditions
The Power Saving Control...
operates electric heaters These heaters help pre-
vent moisture from forming on the outside of the
freezer when humrdity IS high
1 else the OFF setting when humrdrty
IS low
2 Use the ON setting only If moisture forms on the
outside of the freezer
Changing the light bulb...
Adjusting the pull-out basket...
To remove basket:
1 Remove food from basket.
2. Slide basket out to stop.
3. Lift front.
4. Slide the rest of the way out
To replace basket:
I. Fit back of basket on top of guide stops on bottom
of guides.
2 Lrft front, then slide the basket untrl it clears the
guide stops.
Adjusting the temperature control...
1 Turn control to higher number for colder temper-
atures
2 Turn to lower number for less cold temperatures
Cooling freezer first...
1 Allow freezerto cool 6 to 8 hours before filltng with
frozen food.
2 Let it cool overnrght before adding large amount
of unfrozen food.
Note: When freezer is first started, the compressor
will
run constantly until the cabinet is cooled It may
take up to 6 to 8 hours or longer, dependrng on room
temperature and the number of times the freezer
door
IS
opened
After the cabinet
IS
cooled, the compressor will
turn ON and OFF as needed to keep the freezer at
the proper temperature
WARNING: To avold posslble shocks, first unplug
treezer or turn off electrlclty leadlng
to freezer at the maln power supply.
1 Remove the light shield from the side of the control
panel Depress the back of the shield to release the
tabs, then pull away
2 Replace bulb with a 40-watt appliance bulb
3 Replace the light shield Insert the shield tabs in the
slots. then press the shield to snap Into place