Filter
Top Products
Removing the bottom trivet...
To remove:
1 Lift front of trivet out of supports
2 Pull out
Lift the Front,
Then Pull Out.
To replace:
1 Posrtfon back of trivet on the rear wall supports
2 Lower front lr,to place
The key eject lock...
can help reduce the hazard of chfld
entrapment
/
The signal light...
automatfcally warns of any unexpected
power failure
Signal Light
/
If the signal light is not glowing. fmmediately check
0 for power interruption,
l
for an unplugged power cord,
l
for a burned out signal light
Energy saving tips...
You can help your freezer use less electricity
l
Set Temperature Control to provide temperatures
l
Check door gasket and level freezer to assure a
around 0 F [ 17 8 C] There
IS
no need to store
good door seal
foods below 0 F
l
Clean the condenser
coils
regularly
l
Keep door openings to a minimum Remove several
Items at one ttme Keep contents organized to elrmr-
note searching
l
FIII to capacity Follow recommended procedures
for freezing foods See pages 8 and 9
l
Keep door looked to ensure door closure
l
Do not let frost bufld up to more than % Inch (6 mm)
thick Efficiency
IS
reduced
l
Keep Power Saving Control on OFF when humidfty IS
low
To lock or unlock the freezer you must hold the
key In the lock while turning The lock IS spring
loaded so the key cannot be left in the lock
If the key IS lost, contact your WHIRLPOOL
dealer for a replacement Always give the com-
plete model and serial number of your freezer
when requesting a replacement key.
To replace burned out signal light:
1 Unplug power cord from outlet.
2 Open the freezer door
3 Push out signal light from behind, then unplug
burned out light. Replace light with one of
the same wattage and size. Signal light can
be ordered from your WHIRLPOOL dealer,
Part No. 1103639
4 Close freezer door and plug power cord into
outlet.
6