Filter
Top Products
Before you plug it in
Before using your freezer, you are personally
responsible for making sure that it...
l
is installed and leveled on a floor that will
hold the weight, and in an area suitable for
its size and use.
l
is connected only to the right kind of outlet,
with the right electrical supply and
grounding.
l
is used only for jobs expected of home
freezers.
l
is not near an oven, radiator or other heat
source.
l
is prc perly maintained.
l
is in cd dry sheltered place.
l
is use83 in an area where the room tempera-
ture vill not exceed 110°F (433°C).
l
is not run where there are explosive fumes.
l
is not Ilsed by children or others who may not
understand how it should be used.
l
is not loaded with food before it has time to
get properly cold.
Install Properly.. .
1 inch in back1
1. Check the strength of the floor It should hold
the weight of fully loaded freezer.
2. Pick a sate place, indoors, away from in-
flammables such as gasoline.
3. Allow at least 3 inches (7.5 cm] air space on
top of freezer and 1 tnch (2.5 cm] at back be-
tween condenser and wall.
level Freezer.. .
so that door will stay open at any position.
1. Remove base grille (see page 4 1. 7
1
2. Starting with door hinge sid
turn left to raise corner.
3. Turn right to lower corner
4. Check with level
5. After freezer is loaded with
food, recheck with level.
2
Raise
Lower
Remove Sales labels...
Rem’)ve the Consumer Buy Guide label and
any inm#ide labels before using the freezer. Re-
move crny left over glue with rubbing alcohol.
I
Notcr: DC NOT REMOVE the Tech Sheet fas-
tene.1 behind the base grille.
I
Cleaii It...
Clean your freezer before using it. See clean-
ing instructions on page 5,
Plug it in...
3-prong grounding
type wall receptacle
Freeze1
power .:ord
Recommended Grounding
Method
A 12L Volt, 60 Hz., AC only, 15 ampere fused
electric al supply is required. It is recommended
that a separate circuit serving only this appli-
ance t e provided. The receptacle should not
be conlrolled by a wall switch or pull chain.
Do not use an extension cord.
See ndividual electrical requirements and
grounding instruction sheet in your literature
packa! re.