Filter
Top Products
Using your freezer
Setting the Cold Control...
To start, turn control to the middle of the dial.
This setting will maintain zero zone temperatures
under normal operating conditions.
Adjusting Cold Control. . .
Bottom Trivet...
l
Turn control to higher number for colder
temperatures.
l
Turn to lower number for less cold temperatures.
Cooling Freezer First.. .
l
Allow freezer to cool 6 to 8 hours before filling
with frozen food.
l
Let it cool overnight before adding large
amount of unfrozen food.
Note: When freezer is first started the compressor
will run constantly until the cabinet is cooled. It
may take up to 6 to 8 hours or longer, depending
on room temperature and the number of times
the freezer door is opened.
After the cabinet is cooled the compressor will
turn on and off as needed to keep freezer at
proper temperature.
lo remo\:e:
Toreplace:
l
Lift up, ihen pull out.
l
Set in bottom of freezer.
l
Push into place.
Freezer Shelves...
j-j
/A--
To remo>)e:
Lif frorlt slightly, then lift shelf from back supports.
To repla ::e:
Set bock of shelf on rear supports then lower
the front 3n to front mounts.
Exterior Signal light...
automatically warns of any unexpected power
failure.
If the signal iight is not glowing, immediately
check:
0 for power interruption,
l
the power cord: it may be disconnected from
the outlet,
l
the signal light; it moy be burned out.
To replace burned out signal light:
1. Unplbrg power cord from outlet.
2. Remc tie base grille. See page 4.
3. Unpll.3 burned out light and replace with one
of same wattage and size. Signal light can be
ordered from your WHIRLPOOL dealer, Part No.
530504.
4. Replclce base grille. See page4.
5. Plug I)ower cord into outlet.
3