Filter
Top Products
Install properly...
1.
2.
3.
4.
5.
6.
Check the strength of the floor It should hold the
weight of a fully loaded freezer.
Pick a sate place, indoors, away from in-
tiammabies such as gasoline.
Allow 3 inches (7.5 cm] air space on top of freezer
for proper ventilation.
Allow at least an inch (2.5 cm] between the
freezer condenser, on the back of the unit, and
the wall.
Allow J/Z inch (1.25 cm) on each side of the freezer
for ease of installation
If the freezer is to be against a wall, you might
want to leave extra space on the hinge side so the
door can be opened wider.
Level freezer...
so the door will stay
open at any position.
Levelling Leg
wer
I. Keep the 4 bolts that hold freezer in shipping crate.
They are the levelling legs.
2. Screw these bolts all the way into bolt holes in the
bottom corners of freezer. Move freezer into place.
3. Adjust each leg until the freezer won’t rock.
4. Adjust front legs to level the freezer.
- To raise corners, turn legs in direction shown,
-To lower corners, turn legs in direction shown.
5. Check with level.
Remove sales labels...
Remove the Consumer Buy Guide label and any
inside
labels before using the freezer.
To remove any remaining glue:
1. Rub briskly with thumb to make a ball, then
remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) be-
fore removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetmchioride, etc. there can damage the
material.
NOTE: DO NOT REMOVE the Tech Sheet fas-
tened under the treezer at the tront.
Clean it . . .
Clean your freezer befor
using it. See cleaning
instructions on page 6.
Plug it in...
j-prong grounding
type wail receptacle
Retainivg Clip
p;kr;wg/ ‘::!I
1
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused
and properly grounded electrical supply is required.
It is recommended that a separate circuit serving
only this appliance be provided.
Use a receptacle
which cannot be turned off with a switch or pull
chain. Do not use an extension cord.
Attach retaining clip over power cord plug from
literature package inside the freezer.
See individual electrical requirements and ground-
ing instruction sheet in your literature package.
4