Whirlpool GDP8500 Dishwasher User Manual


 
Water temperature tips
Hot water dissolves and activates the
dishwashing detergent. Hot water also
dissolves grease on dishes and helps dry
glasses spot-free. The dishwasher will
automatically heat water to 135°F (57°C)
during the final rinse. Use the Hi-Temp
Wash option if you keep your water heater at
a bw setting.
For best dishwashing results, water must
be at least 120°F (49°C) as it enters the
dishwasher.
To check water temperature
1. Run hot water at the faucet closest to
your dishwasher. Let the water run for at
least one minute.
2. Measure the water temperature with a
candy or meat thermometer. Put the
thermometer in the running stream
of water.
3. If the water temperature at the faucet is
below 120°F (49”C), have a qualified
person raise the water heater’s thermo-
stat setting.
Energy saving tips
You can help save energy if you:
l
Wash full loads. Running a half-filled
dishwasher uses the same amount of
electricity and hot water as a fully loaded
machine.
9 Use the Light Wash Cycle whenever
possible. The cycle uses less hot water
and energy than the Normal Wash Cycle.
l
Use the Air Dry option when you don’t
need a rapid drying cycle. Allow longer
drying times (overnight). Use a rinse agent
to improve drying.
l
Do not use the Hi-Temp Wash option.
When this option is off, the dishwasher will
not pause to heat water to 135°F (57°C)
during the main wash.
NOTE: Loads may not wash as well if the
water temperature is too low.
l
Load correctly for best washing results.
Incorrect loading may cause poor washing
and the need to rewash all or part of
the load.
l
Do not pre-rinse normally soiled dishes.
Select the correct cycle for the load and
use the recommended amount of detergent
for good washing results without hand
rinsing.
l
Use your dishwasher during off-peak
hours. Local utilities recommend this to
avoid heavy usage of energy at certain
times of day.
13