Filter
Top Products
Adding a dish during a cycle
You can add a forgotten item to the dishwasher anytime before the Cycle Control knob
reaches LIGHT WASH. See page 8.
1.
2.
3.
Lift up on the door latch to unlatch the
seconds for air in the dishwasher to warm
door and stop the cyde. Wait a moment
up. Thii helps reduce the amount of
for the spray action to stop before open-
moisture that can come from the vent
ing the door.
when restarting the cycle.
Open the door and add the dish.
4. Press door in to latch ft. The dishwasher
Close
the door.
Do not latch It.
Wait
30
will start where it stopped.
Changing a cycle setting
You can change a setting anytime during any cycle.
1.
2.
3.
4.
Lift up on the door latch tounlatch the
door and stop the cycle.
Turn the Cycle Control knob clockwise to
the cycle you want.
Push the desired Cycle Selection button.
Check the detergent dispenser to be sure
it is properly filled for the new cycle. See
page 10.
NOTE: Turning the Cycle Control knob
may cause the covered section of the
detergent dispenser to open. Be sure to
fill the covered section if the cycle uses
detergent in both sections.
5. Close and latch the door. The dishwasher
will automatically start the new cycle.
Changing an option
You can change an option anytime during a
cycle. To change the selected option(s):
1. Push the RESET OPTIONS button.
2. Push an Option Selector button for each
desired option.
Canceling a cycle
You can cancel a cycle anytime during the cycle.
1.
Turn the Cycle Control knob slowly 2. Let the dishwasher drain completely.
clockwise to the drain portion of the wash
or rinse. You will hear water draining
3. Lift up on the door latch to unlatch the
door.
when you have advanced to the proper
location.
4. Turn the Cycle Control knob clockwise to
point to OFF.