Whirlpool GDP8500 Dishwasher User Manual


 
Using Your Dishwasher
In This Section
Page
Before starting your dishwasher
...... .
Starting
your dishwasher .................
.6
Adding
a dish during a cycle..
.......... .7
Changing
a cycle setting ..................
.7
Changing an option
............................
7
Canceling a cycle
.” ............................
7
Cycle selection chart
..........................
8
Page
What happens In each option
............ 9
Using the detergent
dispenser..
.....
.I0
Using the rinse agent dispenser.. ..
.11
Quiet operating tips
.......................... 12
Water temperature
tips
...................
.13
Energy saying tips
............................ 13
Special tips on dishwasher use ....
..14
Operating your dishwasher properly enables you to obtain the best possible results. This
section explains proper dishwasher operation.
Before starting your dishwasher
1. Properly bad the top rack, bot-
tom rack, and thesilverware bas-
ket. See pages 15-17.
4. Check the rinse agent dispenser.
See pages 11 and 12.
2.
Spin both spray arms with both
racks in place to make sure noth-
ing prevents arms from turning
freely.
5. Push door firmly when closing
and it will automatically la_‘&
3. Add detergent. See pages 10
and 11.
6. Run hot water at sink nearest
dishwasher until water is hot.
Turn off water.
Starting your dishwasher
The dishwasher will wash and dry dishware according to the selections you make on the
control panel.
1
Push a Cycle Selector button
for the desired cycle. The
indicator above the button will
show red for the selected
cycle.
NOTE: Normal Wash, Light Wash and
You will reel a
Rinse & Hold cycles share the same
definite stop at each cycle mark. The
button. The Cycle Control knob determines
dishwasher will automatically start the
which cycle operates.
cycle you selected.
2. Push an Option
Selector button for
each desired option.
The indicator above the
button will show red for
the selected option.
6
NOTE: lf the door is latched, you will hear
cycles start and stop as the knob passes
each cycle mark. This is normal and will
not hurt the dishwasher. If you prefer, you
can set cycles with the door unlatched.