Filter
Top Products
28
RACK SUPPORTS
Clean often to avoid soil buildup. Soil buildup may lead to arcing
and cause damage to the oven.
Do not attempt to remove supports from cavity walls.
Do not use soap-filled scouring pads, abrasive cleaners, steel-
wool pads, gritty washcloths or some recycled paper towels.
■ Mild, nonabrasive soap or detergent and washcloth,
toothbrush or cotton swab:
Rinse with clean water and dry with soft, lint-free cloth.
Replacing Filters
The grease filters should be removed and cleaned at least once a
month. The charcoal filters cannot be washed and should be
replaced every 6 to 12 months. Do not operate the oven without
the filters in place. See “Replacement Parts” section in
“Assistance or Service” to reorder filters. See “General Cleaning”
for cleaning instructions.
To Remove/Replace:
1. Squeeze the small tab on the outer edge of the filter frame
inward, and pull down until the frame and filters drop out.
2. Replace the filters by inserting the long tab of the filter frame
into the inner portion of the filter housing, then swinging the
outside of the frame up until it fits into place.
Replacing Cooktop Light
The cooktop light consists of two 10W low-voltage halogen
capsule bulbs. See “Assistance or Service” section to reorder.
You will need a TORX
®†
T10 screwdriver to remove the bulb cover
mounting screw.
To Replace:
1. Unplug oven or disconnect power.
2. Remove bulb cover mounting screw, and gently open cover.
3. Remove the burned-out bulb.
4. Replace bulb, using a tissue or wearing clean cotton gloves
to handle the bulb. Do not touch bulb with bare fingers.
5. Close bulb cover and replace mounting screw.
6. Plug in oven or reconnect power.
A. Retaining tab
B. Filter frame
C. Grease filter
D. Charcoal filter
A. Filter frame
B. Small tab
C. Grease filter
A B C D
A
B
C
A. Filter frame
B. Long tab
C. Microwave oven bottom
A. Mounting screw
B. Bulb cover lens
C. Halogen bulb
A B C
†®TORX is a registered trademark of Textron Innovations Inc.
A B C