Whirlpool GSC278 YGSC278 Oven User Manual


 
6
ELECTRONIC OVEN CONTROL
Displays
When power is first supplied to the appliance, everything on both
displays will light up for 5 seconds. Then, “PF id = 27” or “PF id =
30” will appear on the lower oven display. Press OFF/CANCEL to
clear display.
Any other time “PF id = 27” or “PF id = 30” appears, a power
failure occurred. Press OFF/CANCEL and reset the clock if
needed.
Lower Oven Display
When the lower oven is in use, this display shows the lower oven
temperature, heat source(s) and start time.
During lower oven Timed Cooking, this display also shows a
vertical bar and minute time countdown and the stop time (if
entered).
If “Err” appears on the display, an invalid pad was pressed.
Press OFF/CANCEL and retry your entry.
When the lower oven is not in use, this display is blank.
Upper Oven Display
When the upper oven is in use, this display shows the upper oven
heat source(s), cooking power, quantities, weights and/or help
prompts.
If “RETRY” flashes on the display for one second, an invalid pad
was pressed. Retry your entry.
When the upper oven is not in use, this display shows the time of
day or Timer countdown.
Start/Enter
The lower oven START/ENTER pad begins any lower oven
function except the Timer. If not pressed within 5 seconds after
pressing a pad, “START?” will appear on the lower oven display
as a reminder. If not pressed within 5 minutes after pressing a
pad, the oven display will return to inactive mode (blank) and the
programmed function will be cancelled.
Off/Cancel
The lower oven OFF/CANCEL pad stops any lower oven function
except for the Clock, Timer and Control Lock.
The cooling fan may continue to operate even after the lower
oven OFF/CANCEL is pressed depending on the oven
temperature.
Clock
This is a 12 hour clock and does not show a.m. or p.m.
To Set:
Before setting, make sure the ovens, Timer and Timed Cooking
are off.
1.
Press CLOCK.
2.
Press the number pads to set the time of day.
3.
Press CLOCK, START/ENTER or ADD MINUTE START.
To remove the time of day from the display:
Press and hold
CLOCK for 5 seconds.
To return the time of day to the display:
Press CLOCK. The
time should not have to be reset.
Tones
Tones are audible signals, indicating the following:
One tone
Valid pad press
Oven is preheated
Function has been entered
Three tones
Invalid pad press
Four tones
End-of-cycle
Reminder, repeating each minute after the end-of-cycle tones
1.
Lower Oven Display
2.
Number Pads
3.
Upper Oven Display
4.
Clock
5.
Timer
6.
Lower Oven Selectors
7.
Timed Cooking
8.
Lower Oven Start/Enter [Control
Lock] and Lower Oven Off/Cancel
9.
Oven Light
10.
Upper Oven Control
(see separate Use and Care Guide)
1 2 3 4 5
6 7 108 9