Filter
Top Products
6
For best drying
results, dry dishes
with heat.
Turn OFF when loads contain plastic dinnerware that may be
sensitive to high temperatures.
This option with the use of rinse aid will provide the best drying
performance.
Available with any cycle
except Rinse Only.
To run your dish
washer at a later
time or during off-
peak hours.
Delays the start of a cycle up to 6 hours.
Select a wash cycle and options. Press Delay until reaching the
desired hours for the delay to start. Press START/RESUME. Close
the door firmly.
All cycles, except Rinse
Only
To run your dish
washer at a later
time or during off-
peak hours.
Delays the start of a cycle 4 hours.
Select a wash cycle and options. Press Delay until reaching the
desired hours for the delay to start. Press START/RESUME. Close
the door firmly.
All cycles, except Rinse
Only
Control Lock To avoid unintended
use of your
dishwasher, or cycle
and option changes
during a cycle.
To turn on Lock, press and hold Heated Dry for at least 4 seconds.
To turn off Lock, press and hold Heated Dry for at least 4 seconds.
When Control Lock is lit, all buttons are disabled. If you press any
pad while your dishwasher is locked, the light flashes 3 times. The
dishwasher door can be opened while the controls are locked.
Anytime
OPTION SELECTIONS
OPTIONS DISH LOAD TYPES DESCRIPTIONS USE WITH:
CONTROLS AND
CYCLE STATUS
CONTROL PURPOSE COMMENTS
To start or resume a
wash cycle
If the door is opened during a cycle or the power is interrupted, the Start/Resume indicator
flashes. The cycle will not resume until the door is closed and Start/Resume is pressed.
To cancel wash
cycle
Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher
drain completely.
To follow the
progress of your
dishwasher cycle
The “Washing” indicator glows at the start of the first fill of any cycle (except Rinse Only) and
remains on until the end of the main wash cycle.
To follow the
progress of your
dishwasher cycle
The “Drying” indicator glows during the drying portion of each cycle (except Glass Xpress and
Rinse Only).
To follow the
progress of your
dishwasher cycle
“Clean” indicator glows when a cycle is finished.
If you select the Sani Rinse option, when the Sani Rinse cycle is finished, the “Sanitized”
indicator glows. If your dishwasher did not properly sanitize your dishes, the light flashes at the
end of the cycle. This can happen if the cycle is interrupted, or the water could not be heated to
the required temperature. The light goes off when you open and close the door or press
CANCEL.