7
Dishwasher Features
Your Whirlpool dishwasher may have some or all of these features.
POWERSCOUR™ Wash Area
The POWERSCOUR™ wash area is located
at the back of the lower level rack.
NOTE: You must select the
POWERSCOUR™ wash option to use this
feature. Make sure items do not interfere
with the water feed tube, spray arms, or
POWERSCOUR™ spray jets.
■ Load pans, casserole dishes, etc. in the
back of the lower dish rack with the
soiled surfaces facing the
POWERSCOUR™ spray jets.
■ Only one row of items may face the POWERSCOUR™ spray
jets. Stacking, overlapping or nesting items will keep the
POWERSCOUR™ spray jets from contacting all of the
surfaces.
ANYWARE™ PLUS silverware basket
The ANYWARE™ PLUS silverware basket can be hung on the
door, the bottom rack, or placed inside the bottom rack.
To open the ANYWARE™ PLUS silverware basket:
Unlock the latch.
NOTE: Be sure the cover is completely latched before pulling out
the bottom rack and before closing the dishwasher door.
To remove the basket from the door:
1. Grasp the silverware basket by the handle. Slide it toward the
top of the door.
2. Lift the basket off the holding buttons.
To replace the basket in the door:
1. Set the silverware basket on the holding buttons.
2. Slide the basket toward the bottom of the door until is locks
into place.
Cup shelves
Fold down the extra shelf on the left-
hand or right-hand side of the top rack
to hold additional cups, stemware or
long items such as utensils and
spatulas.
Fold-down Tines
The row of tines on the left-hand and
right-hand sides of the mid-level rack
can be adjusted to make room for a
variety of dishes.
To adjust the fold-down tines:
1. Grasp the tip of the tine that is in
the tine holder.
2. Gently push the tine out of the
holder.
3. Lay the tines down, toward the
center of the rack.
Light Item Clips
The light item clips hold lightweight plastic items
such as cups, lids, or bowls in place during
washing.
To move a clip:
1. Pull the clip up and off the tine.
2. Reposition the clip on another tine.
Side clip
The side clip holds
lightweight plastic items
such as cups, lids, or
bowls in place during
washing.
To move a clip
1. Pull the clip up and off
horizontal rack wire.
2. Reposition the clip on
another horizontal rack
wire.
Utensil clip
The utensil clip holds specialty cooking items (wooden spoons,
spatulas, and similar items).
To move a clip
1. Pull the clip up and
off horizontal rack
wire.
2. Reposition the clip
on another
horizontal rack
wire.