Before you start.. .I
Check the area where you will be
cising your portable dlshwasher.
Proper installation for operation IS
your respcnsibillty Make sure you
have everything necessarv to
ixure correct operation
IS required See Electncui
Hot water faucet or hot and
cold single-spout water faucet:
The faucet should be accessible
within 4 feet of the back of the
dishwasher and should provide
-
15-I 20 PSI water pressure
Water Heater: Should be sei to
deliver 14O’F water to dishwasher
for best results
Important: observe all governing
codes and ordinances.
9emove parts and literature
packages frcr? dishwasher tub
Ciose and latch dfshwasber door
\
Tools needed for
installation.
Parts sup
lied
for
insta
l?
atfon.
1 literature package
3 faucet adapter kits
PANEL A
4
casters
Electrical
requirements.
Warning: Improper connection of the
equipment grounding conductor can
result in a risk of elect&al shuck.
Electrical ground is required on this
appliance.
A 120 Volt, 50/60 Hz, AC only 15 Ampere
(20 Ampere maximum) fused electrical
supply is required. (Time-delay fuse or
circuit breaker is recommended.) It is
recommended that a separate circuit
serving only this appliance be provided.
WARNING: AN EXTENSION CORD
SHOULD NOT BE USED WITH THlS
APPLIANCE. SUCH USE MAY RESULT
IN A FIRE, ELECTRICAL SHOCK,
OR OTHER PERSONAL INJURY
In areas where the recommended
voltage is not available, it is necessary
to install a transformer with a minimum
rating of 1500 watts. The output voltage
of the transformer must be 120 volts. If the
transformer does not provide for an
electrical ground, a separate external
grounding wire must be installed in
accordance with local codes and
ordinances. Such a transfomer can be
purchased locally, See Figure I.
120 volt
inwt into
Transformer
Support: The floor must be able to
support the appliance weight of
180 pounds.
Drain: To drain your Whirlpooi
dishwasher, you need a sink or a
laundv tub having a mlnlmum
carry-away capacity of 7 gallons
per minute. The top of the sink or
laundry tub cannot be lower than
27 inches or higher than 48 inches
from the bottom of the dishwasher
Recommended
grounding
method.
DO NOT, UNDER ANY
CIRCUMSTANCES, REMOVE THE
POWER SUPPLY CORD
GROUNDING PRONG.
For your personal safety, this appliance
must be grounded. This appliance
is equipped with a power supply cord
having a 3-prong grounding plug. To
minimize possible shock hazard, the
cord must be plugged into a mating 3-
prong grounding type wall receptacle,
grounded in accordance with the
National Electrical Code, ANSI/NFPA
70-1987 and local codes and
ordinances. See Figure 2. If a mating
wall receptacle is not available, it is the
personal responsibility and obligation
of the customer to have a properly
grounded 3-prong wall receptacle
installed by a qualified electrician.
3-prong
grounding type
wall receptacle
I- l-iabcb
Groundina
Figure 2
Figure 1