Filter
Top Products
faucet
adapter
4
bleeder
button
locking
collar
10.
Turn on hot water until water is hot. Turn
faucet off. Pull the inlet/drain hose from
the storage compartment. Attach the
hose connector to the faucet by pulling
down on the locking collar while
pushing the connector over the faucet
adapter. It will snap into place. Release
the locking collar.
PANEL C
Untape the electrical cord and-
into the grounded outlet. Open the
I
dishwasher door and spin the spray
arm to check for movement. Close the
door.
12,
Slowly turn on hot water to fully open
position. Start dishwasher.
Check for leaks around the door,
/
I
mounting gasket, and at the hose
connections. Open door and check
water level, Water shoutd just cover
the round heater element. Close door
and allow dishwasher to complete
one cycle.
faucet
adapter
w
locking
14.
When the cycle is completed, turn the
water “OFF.” Press the red button
[bleeder button) on the connector to
release water pressure. With one hand,
move the locking collar downward
while using the other hand to pull down
on the connector. Turn the connector
upside down to empty any water
remaining inside the connector, Check
for complete drain (no water should
be visible).
bleeder button
15,
Push hoses into storage compartment.
dishwasher. To make sure you get the
most efficient use and greatest
enjoyment from your new dishwasher,
( Congratulations! \
Installation
To convert a front loading portable
dishwasher into a built-in model, you
need the Conversion Kit No. 559056
available from your Whirlpool dealer.