Whirlpool MB7120XY Microwave Oven User Manual


 
Installation Instructions
Before you begin operating the oven, carefully read
the following instructions.
Installing your microwave oven
1. Empty the microwave oven and dean inside it
with a soft, damp cloth. Check for damage such
as misaligned door, damage around the door or
dents inside the oven or on the exterior. If there
is any damage, do not operate the unit until it
has been checked by an authorized WhirlpoolSM
service technician and any repairs made.
26
2. Put the oven on a cart, counter. table or shelf
that is strong enough to hold the oven and the
food and utensils you put in it. (The control
side of the unlt Is the heavy side. Use care
when handllng.) The weight of the oven is
approximately 35 Ibs (15.75 kg).
3. Do not block the rear alr Intake openlngs or
exhaust vents. Allow a few inches of air
circulation at back of oven where intake
openings and exhaust vents are located.
Blocking the air intake openings and exhaust
vents can cause damage to the oven and poor
cooking results. Make sure the microwave oven
legs are in place to ensure proper airflow.
//I \
Power supply cord
Do not Install the oven n&t to or over a heat
source (for example, a cooktop or range) or
Alr intake openlngo
Exhauot VCWIIS
) outslde of the cabinet.
ln any area where excessive heat and steam
are generated. Thls could damage the
Product Damage Hazard
I
Built-In klt
You can build-in your oven by using one of the
following kits:
-24” for MB71 20XY (Kit No. 4313646)
-2irfor MB712OXY (Kit No. 4313601)
These kits are available from your Whirlpool
Dealer. lf your dealer does not stock the kii it can
be ordered by writing to:
Whirlpool Corporation
Attention: Customer Service Dept.
1900 Whirlpool Drive
LaPorte, IN 46350