Filter
Top Products
Using Your Microwave Oven
Continued
Audible signals
Audible signals are available to guide you when
setting and using your oven. A programming
tone will sound each time you touch a pad. Two
beeps will sound between cycles. A reminder
tone will sound every 30 seconds after cooking is
done to remind you that something has been left
in the oven. Four beeps signal the end of the
Minute Timer function and a Cook or Defrost
cycle. If you don’t hear a tone, it is because of
incorrectly entered instructions or because the
tones have been removed. For example, a tone
will not sound if you touch a Number Pad before
you touch a Command Pad.
To
remove the programming tone:
1. Open the door.
2. Touch CANCEL
twice,
then touch START.
3. Programming tones will be cancelled.
To replace the tones:
l
Repeat the steps above.
To remove all tones:
1. Open the door.
2. Touch CANCEL
twice,
touch 0, then touch
START.
3. All audible tones (including Minute Timer signal)
will be cancelled.
NOTE:
Do not remove all tones if you use the
Minute Timer.
To replace the tones:
l
Repeat the steps above.
NOTE:
If your electricity goes off, the audible
signals will come back on. Repeat steps
above
if
you want to remove them again.
Setting the clock
When the oven is first plugged in, a tone sounds
and the Display shows 88:86. If the electric power
ever goes off, the Display will again show all 8’s
when the power comes back on.
You can cook without setting the clock, but the
Display will be blank after cooking.
1. Touch CLOCK SET. The Display will show a “0”
and the colon will star? to flash. The
first
Number Pad must be touched withln 5
seconds or the Display will go blank.
If the
Display goes blank, touch CLOCK SET again
and continue.
10