Filter
Top Products
Using Your Microwave Oven
Continued
Audible signals
Audible signals are available to guide you when
setting and using your oven. A programming
lone will sound each time you touch a pad. Two
beeps will sound between cycles. Three beeps
signal the end of the Minute Timer function and a
cook or defrost cycle. If you don’t hear a tone, it
is because of incorrectly entered instructions. For
example, a tone will not sound if you touch a
Number Pad before you touch a Command Pad.
Setting the clock
When the oven is first plugged in, the Display
shows “:O”. If the electric power ever goes off,
the Display will again show “:O” when the power
comes back on.
You can cook without setting the clock.
1.
2.
3.
To set the clock, touch CLOCK SET and the
Display will show a “0”.
Touch Number Pads for the correct time of
day. The Display will show what numbers you
touched in the order you touched them.
This example shows 325.
Touch CLOCK SET. The Clock is set. If you
have touched in an incorrect time, such as
12:65, “E” will show on the Display and two
beeps will sound. Touch CANCEL and then
CLOCK SET and start over.
NOTE: To reset the clock, touch CLOCK SET.
The current time will show on the Display and the
colon will go off. Continue to set the clock as
shown above.
10