Filter
Top Products
installation Instructions
Before you begin operating the oven, carefully read the following instructions.
Installing your microwave oven
1. Empty the microwave oven and clean
inside it with a soft, damp cloth. Check for
damage such as misaligned door, damage
around the door, or dents inside the oven or
on the exterior. If there is any damage, do
not operate the unit until it has been
checked by an authorized WhirlpoolSM
service technician and any repairs made.
2. Put the oven on a cart, counter, table, or
shelf that is strong enough to hold the oven
and the food and utensils you put in it. (ll~e
control slde of the unlt Is the heavy side.
Use care when handllng.) The weight of
Model MT2070XA is approximately 35 Ibs
(15.75 kg). The weight of Model MT3090XA
is approximately 50 Ibs (22.5 kg). The
microwave oven should be at a temperature
above 50°F (10%) for proper operation.
(Rear
exhaust
vents for
Model
MT2070XA-
not shown)
Exhaust vents
(Model MT3090~ only)
Power
supply
cord
Exhaust vents (not sho?m)
Air intake openings
Fire, Electrkal Shock, Excesslvo Ex~o-
sure To Mlcrowave Energy, Personal
InJury and Product Damage Hazard
l Do not block the rear air intake openings
or exhaust vents. Allow a few inches of
space at back of oven where intake
opening and exhaust vents are located.
Blocking the air intake openings and
exhaust vents can cause damage to the
oven and poor cooking results. Make
sure the microwave oven legs are in
place to ensure proper airflow.
l Do not install the oven next to or over a
heat source (for example, a cooktop or
range). Also, do not install oven in any
area where excessive heat and steam
are generated. This could cause a fire,
electrical shock, excessive exposure to
microwave energy, other personal injury
or damage to the outside of the cabinet.
Built-in kits
You can build your microwave oven into a wall
or cabinet by using one of the following kits. Do
not build in your microwave oven within 2 feet
of any gas or electric range, cooktop or oven.
For Model MT3OQOXA:
- 24’ for black models (MK30Q4XAB
[43 192491)
-24’ for white models (MK30Q4XAQ
[43 192481)
For Model MT207OXA:
- 24’ for black models (MK2074XAB
[4378054])
- 24’ for white models (MK2074XAQ
[4378053])
These kits are available from your Whirlpool
Dealer. If your dealer does not stock the kii, it
can be ordered by writing to:
Whirlpool Corporation
Attention: Customer Service Dept.
1900 Whirlpool Drive
LaPorte, IN 46350
OR by returning the customer order card
enclosed with your Use and Care Guide.