Filter
Top Products
A-2. Install the Mounting Plate
Step. 1 Setup position
a. Draw a line down the middle of the studs(See the WallConsa_ction, page 5)
b.Draw avertical line on the wall at the center ofthe 30"wide space.
NOTE: Use the wall template for the rear wall.
Reference Wall Template prior to proceeding.
Installation of this product require TWO persons.
Step. 2 Drilling
Referencethe WallTemplate.
Step. 3 Install the damper
Fit the damper into the house duc_ Be sure that the damper hinge is on the top and the dotnper
free into the wall outlet.
Takethe28"foam
tapesandremove
thepaperfrom
stickyside.Press
thestickysideonto
the front edge ofthe
damper. (Don't
stretch the foam
tape)
Plate
Step. 4 Tightening the screws
ToAttach the mounting plate to the wall using thetoggle bolt assemblies and/or lag screws: