Filter
Top Products
Replacing
1
2. Line up opening in the reflector
bowl with the surface unit
receotacle.
3. Hold the surface unit as level as
possible with the terminal just
started into the receptacle.
4. Push the surface unit terminal into
the receptacle. When the terminal
is pushed into the receptacle as
far as it will go, the surface unit will
fit into the reflector bowl.
CAUTION: Reflector bowls reflect heat back to the utensils on the
surface units. They also help catch spills. When they are kept clean,
they reflect heat better and look new longer.
If a reflector bowl gets dlscolored, some of the utenstls may not be flat
enough, or some may be too large for the surface unit. In either case,
some of the heat that’s meant to go into or around a utensil goes down
and heats the reflector bowl. This extra heat can discolor it. See
“Cooking Guide” for further information.
Lift-Up Cooktop
1.
Make sure all controls are OFF.
2. Remove griddle cover, griddle
and a front surface unit.
3. Lift front of cooktop at surface unit
opening.
4. Carefully lowerthe cooktop onto
the support rod.
5. Wipe up any spills under the
cooktop with warm soapy water. Use
soapy steel wool pad on stubborn
spots.