Filter
Top Products
Before Using Your
Refrigerator
It is important to prepare yourrefrigerator for use. This section tells you how to clean it,
connect it to a power source, install it and level it.
Cleaning your refrigerator
Removing packaging materials
NOTE:
Do not remove any permanent
Remove tape and any inside labels (except
instruction labels inside your refrigerator. Do
the model and serial number label) before
not remove the Tech Sheet fastened under
using the refrigerator.
the refrigerator at the front.
To remove any
remaining glue:
Cleaning it before use
l
Rub briskly with thumb to make a bail,
After removing all packag-
then remove.
q
ing materials, clean your
OR
refrigerator before using it,
l
Soak area with liquid hand dishwashing
j w
if necessary. See cleaning
detergent before removing glue as
instructions on pages 18-l 9.
described above. Do not use sharp
instruments, rubbing alcohol, flammable
fluids or abrasive cleaners. These can
damage the material. See ‘Important
Safety instructions” on page 3.
Plugging it in
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere
fused and properly grounded electriil
supply is required. It is recommended that a
separate circuit serving only this appliance
be provided. Use a receptacle which cannot
be turned off with
a
switch or pull chain. Do
not use an extension cord.
See Electrical Requirements and Ground-
ing Instructions Sheet in your Literature
Package.
3-prong grounding
type wall receptacle
Refrigerator
I
power cord 7
grounding .
Plug
6
WITH QUESTIONS OR COYYENTS