Filter
Top Products
Replacing
Burn, Elecfrlcal Shock and Flre Hazard
l
Make sure all surface units are OFF before replaclng surface units and
reflector bowls. Fallure to do so can result In burns or elecfrlcal shock.
l
Do not line the reflector bowls wlfh foil. Fire or electrical shock
could resutf.
1.
Turn off all surface units.
1. Line up openings in the reflector
bowl with the surface unit recep-
tacle and the element hold down
clip
3. Hold the surface unit as level as
possible with the terminal just
started into the receptacle. Push
the surface unit terminal into the
receptacle.
4. When terminal is pushed into the
receptacle as far as it will go, push
down the edge of the surface unit
opposite the receptacle. The ele-
ment hold down clip will keep the
surface unit from moving around.
NOTE: Reflector bowls reflect heat back to fhe ufenslls on fhe surface
unlfs. They also help catch spills. When they are kept clean, they
reflect heat better and look new longer.
If a reflector bowl gets dlscolored, some of fhe utensils may not be
flat enough, or some may be too large for fhe surface unit. In either
case, some of the heat that’s meant to go info or around a utensil
goes down and heats the reflector bowl. Thls extra heat can discolor
lf. See Cooking Guide for further information.
17