Whirlpool RF375PXY Range User Manual


 
PROBLEM
Self-Cleaning
cycle will not
operate
POSSIBLE CAUSE
SOLUTiON
The Oven Selector and Oven Set both the Oven Selector and Oven
Temperature Control Knob
Temperature Control Knob to CLEAN.
are not set to CLEAN.
The range clock does not
Reset clock to show the correct time
show the correct time of day. of day. (See page 12.)
The Lock Lever is not in the
Move Lock Lever all the way to the
CLEAN positio~ll the way
right.
to the right.
A delayed start time has been Waft for the start time to be reached.
programmed.
Cooking
The range is not level. Level range. (See Installation Instruc-
results are not
ti0l-S.)
what you
expected
The oven temperature is too
See page 15 for instructions on how
bw or too high.
to adjust the Oven Temperature
Control.
The oven was not preheated Preheat oven when called for in
before baking. recipe.
The recipe has never been
Use only tested recipes from a
tested or is not from a reliable reliable source.
source.
The pan used is not the type Refer to a reliable cookbook for
or size recommended in the recommended pan type and size.
recipe.
There is not proper air
Allow li% to 2 inches (4-5 cm) of air
circulation around pan when
space on all sides of pan. There must
baking.
be a minimum space of 1 inch
(2.5 cm).
Cooking utensil does not fit
Pan should be the same size or
the surface unit being used.
slightly larger than surface unit being
used.
The display is
There has been a power
Reset the clock. (See page 12.)
flashing
failure.
“66:66”
“F2” shows in
Call for service. (See Step 3 on
the display
paw W
42