Filter
Top Products
Cleaning and caring for your range
‘r’our range 1s desqned to be easy to clean
\r’ou
~~11 usually wipe off
‘spills and spatters when they happen, but you UIII sometimes want to
clean under and behrnd the control knobs and surface units This sectton
iv111 tell you hoi< to remote those. and U. hat to use i;c hen cleaning
Removing and replacing surface unit control knobs:
1
Be sure the control knobs are set to “OFF“
2
Pull the black knobs straight off
Pull knob and trim ring
straight out. Remember
how the spring goes.
13
If the control has a chrome trim ring. pull it straight off.
1
Was/r the krnobs land tnm rings) 111 ivarm. sudsy water
?
Replace t tit> tnm rings first If the control spring was removed. put
it back exactlv as shown on the left.. small end first.
17
Hold the black knob so it points to “OFF“ Push It straght back on
Hemoving and replacing oven control knobs:
i
Be sure the knobs are set to “OFF ”
L
Pull cacti kriob straight off
i
1L’ash the knobs rn warm. sudsy ilater
1 The knobs art’ not rnterchangeable Make sure vou 11ur ttltz adjust-
able Oven Temperature Control Knob on the right place’. and the
nonadjustable Oven Selector Knob on the other
Removing surface units and reflector bowls:
To remove surface
1 Ftrst. be sure the Surface Unit Controls are all Oi-f-.
and rhat t/l*
unit, lift and pull
surface unrts are cool
straight out.
2.
Lift each surface unit about an inch (2.5 cm) at the edge away from the
plug-irr (receptacle). Pull the unit straight away from the plug-tn. Do
/I /,
not wash surjace
units;
they will burn themselves clean during normal
LI se
j
L.Ift rout tht, :i~fle3Zcx
bo~4li
12