Filter
Top Products
Receptacle
Receptacle
1.
Be sure surface
unit
controls are OFF.
2. Line up opening in the reflector bowl with
the surface unit receptacle.
4. While pushing the surface unit terminal into
the receptacle, lift a little on the edge of
the unit nearest the receptacle.
5. When the terminal IS pushed into the re-
ceptacle as far as it will go, the surface unit
will fit into the reflector bowl.
3. Hold the surface unit as level as possible
with the terminal just started into the
receptacle.
Reflector bowls reflect heat back to the
utensils on the surface units. They also help
catch spills. When they are kept clean, they
reflect heat better and look new longer.
If a reflector bowl gets discolored, some
of the utensils used may not be flat enough.
Or some may be too large for the surface
unit. In either case, some of the heat that is
meant to go into or around a utensil goes
down and heats the reflector bowl. This ex-
tra heat can discolor it.
LIFT-UP COOKTOP
1. Lift the front of the cooktop at the center
2.
and swing the support rod up.
Carefully lower the cooktop onto the
support rod. Be sure the tip of the rod fits in
the notch in the cooktop.
18
3. Wipe with warm soapy water. Use soapy
steel wool pad on stubborn spots
DO NOT let the cooktop bump the upper oven when lifting.
DO NOT drop the cooktop. Damage can result.