Filter
Top Products
When Cook 2 ends, “End”
will show on the Display
and 4 beeps will sound.
(You can stop the beeping
by opening the door or by
touching CANCEL.) “End”
will remain on the Display
and a beep will sound
every 30 seconds until the
door is opened or CANCEL
is touched. The Display will
then show the time of day.
Hints for Cooking With More Than One Cycle.
You can program the
cooking cycles in any order. However, when the
microwave oven is started,
it will automatically go through the cycles
in order-AUTO SET TIME
- COOK I- COOK 2 (or QUICK DEFROST -
STANDING TIME -COOK I- COOK 2 or COOK I- COOK 2 -AUTO SET TEMP
or PROBE TEMR)
Changing or Adding Instructions
You can change times, Cook Powers, or add cycles any time before touching
START or during oven operation.
l
Touch the Cook cycle you wish to change or add (COOK 1 or 2).
l
Touch numbers for new time, if desired.
l
Touch COOK POWER, if change is desired.
l
Touch number for new Cook Power, or touch COOK POWER again if HIGH is
desired.
l
Touch in new cycle and time, if desired.
. Touch START.
Using AUTO SET
Auto Set TIME and TEMP are preset cooking cycles which store commonly
used cooking times and probe temperature settings.
Auto Set TIME
Auto Set TIME provides ten preset times. One to nine minutes at HIGH Cook
Power can be set by touching TIME and the corresponding Number Pad 1-9.
This provides a short-cut method for setting commonly used cooking times.
The Auto Set Chart included with your microwave oven and the Auto Set
Guide on the inner door panel help you use Auto Set TIME to cook various
food items without having to look up the cooking times.
A preset time of 2 minutes, 30 seconds at HIGH Cook Power is available by
touching just the Auto Set TIME pad. The time may be changed to any time
from O-99 minutes, O-99 seconds allowing you to store your favorite cooking
time and Cook Power. See page 19 for instructions.
continued on next page