Filter
Top Products
Removing the oven door
It is easier to clean the oven with the oven door removed.
NOTE: Your new oven has 2 shipping retaining
brackets (held in place with screws). They are located
above the hinge arm slot. Remove and discard
brackets before attempting to remove oven door.
Burn and Electrical Shock Hazard
Make sure all controls are OFF and the oven
door is cool before removing oven door.
Failure to do so can result in burns or electrical
shock.
To remove door:
1. Open the door to the Broil Stop position.
2. Hold the door at both sides and lift up and out.
To replace door:
1. Be sure hinge arms are in the open position.
See illustration.
2. Hold door at both sides and insert hinge arms
into range slots.
3. Push bottom of door toward range with your
knee.
NOTE: Hinge arms must go into the range slots
evenly. Bottom door corners should be in as far
as they can go. If door does not line up, remove
and repeat Steps 1, 2 and 3.
Cleaning chart
Use the following table to help you clean all parts of your range.
PART
WHAT TO USE
HOW TO CLEAN
Control knobs Sponge and warm,
l Turn knobs to OFF and pull straight away from
soapy water control panel.
l Wash, rinse and dry thoroughly. Do not soak. Do
not use steel wool or abrasive cleansers. They
may damage the finish of the knobs.
l Replace knobs. Make sure all knobs point to OFF.
Control panel
Sponge and warm,
l Wash, rinse and dry thoroughly. Do not use steel
soapy water
wool or abrasive cleansers. They may damage
OR
the finish.
Paper towel and
spray glass cleaner
l Do not spray cleaner directly on panel. Apply
cleaner to paper towel.
2