Filter
Top Products
INSTALLATION
Remove and discard tile cantilever shelf packing clips
located just above each shelf where it hooks onto the
frame. To remove the plastic clips, wiggle the clips TURNCLOCKWISETO
sideways and pull straight out. RAISECABINETCORNER
Locating Your Refrigerator
1. Allow a free flow"of air through the front base grille.
2. Your model should not be installed where the room
TURN
temperature will go below 55 degrees F., because it COUNTER-
will not run frequently enough to maintain proper CLOCKWISETO
LOWER CABINET
temperature in the freezer. CORNER
3. For ease of installation, you should leave a space of
about i/2 inch between the refrigerator and adjacent 3. It is not necessary to lock the refrigerator in place.
Howexer, if that is desirable, turn one or both of the
walls or cabinets. If the refrigerator is placed with the
hinge side against a wall, you may want to leave locking feet clocl_dse. They arc located near the
f?contwheels.
additional space so the door can be opened wider.
(Refer to the installation instructions for more If the floor is not level and it is necessary to raise the
detail.) rear of the cabinet, we suggest rolling the rear wheels
onto a piece of pl}_vood or other shim n/aterial.
Important Leveling Information 4. To replace, center the clips iu file cut out areas and
Your refrigerator is equipped with front and back rollers push in until the base grille snaps into place.
so it can be moved away from the wall fbr cleaning. The
Connecting the Appliance
front rollers are adjustable and should be positioned so
the refrigerator sits firmly on the floor aud is level. ] W_g/NG} '_tlis appliance is designed to operate
I on a nominal 1:15"_01t,15 amp, 60 eycte _ne. There
To adjust the front rollers: / should' be ase arate, ?oundedi_ircuit seMng this
P g ,
1. Remove the base grille by grasping the ends, lift and / apptia6ce0nly.D6 n6t use a3aextension cord.
pull out.
This appliance is equipped with a three-pronged
IO1 grounding p]ng tbr vour protection against possible
electrical shock hazards. It nmst be plugged into a
grounding receptacle. Where a standard two-prong wall
receptacle is encountered, it is the personal
. responsibility and obligation of the customer to have it
-'- replaced with a properly grounded three-prong wail
_ receptacle. Do not under any cireulnstaoces, cut or
remove the third (ground) prong from the power cord.
2. To level the refrigerator, use a screwdriver and turn
roller adjusting screws clocGvise to raise the cabinet Do not use an adapter plug.
or couuterclockavise to lower the cabinet.
PAGE 1