Filter
Top Products
4. If ports are clogged, clean with a
6. Turn on the burner to determine if it will
straight pin. Do not enlarge or distort
light. If the burner does not light after
port. Do not use a wooden toothpick. If
cleaning, contact an authorized
adjustment Is needed, call a qualified
Whirlpool service technician. Do not
technician for service.
service the sealed burner yourself.
5. After cleaning the gas tube opening and
ports, replace the burner cap.
Cleaning chart
Use the following table to help you clean
all
parts of
your cooktop.
PART WHAT TO USE
HOW TO CLEAN
Control knobs
Sponge and warm,
l
Turn knobs to OFF and pull straight away from
soapy water
control panel.
l
Wash, rinse, and dry thoroughly. Do not soak.
l
Do not use steel wool or abraslve
cleansers. They may damage the flnish
of the knobs.
l
Replace knobs. Make sure all knobs point to
OFF.
Control panel
and trlm
Sponge and warm,
l
Wash, wipe with clean water, and dry thoroughly.
soapy water
l
Be sure to wring excess water from sponge
OR
before wiping around controls. Excess water in
Paper towel and
or around controls may cause damage to the
spray glass cleaner
cooktop.
l
Do not use steel wool or abraslve cleansers.
They may damage the finish.
l
Do not spray cleaner directly on panel. Apply
cleaner to paper towel.
cooktop
surface
(other than
control panel)
Sponge and warm,
l
Wash, wipe with clean water, and dry thoroughly.
soapy water
l
Use nonabrasive, plastic scrubbing pad on
heavily soiled areas.
l
Do not use abraslve or harsh cleansers.
They may damage the flnlsh.
NOTE: Do not allow foods containing acids
(such as vinegar, tomato, or lemon juice) to
remain on surface. Acids may remove the glossy
finish. Also wipe up milk or egg spills when
cooktop is cool.
Surface burners,
grates, caps,
and contoured
well area
See pages 1 O-l 2 for cleaning instructions.
12