Filter
Top Products
10
USING YOUR RANGE
1. Press CLOCK. The colon flashes during
clock programming.
2. Set the time.
Press the “up” (▲) or “down” (▼) pad(s) until
the correct time shows on the display.
NOTE: Press a pad briefly to change time by a
small amount. Press and hold a pad to change
time by 10 minute increments.
3. Press CLOCK again to start the clock. The
colon stops flashing when the clock is active.
THE ELECTRONIC TIME-OF-DAY (TOD) CLOCK/TIMER
SETTING THE CLOCK
CLOCK
TIMER
TIMER
Oven
timer pad
(p. 11)
Display/clock
• When you first plug in the range, the display
flashes time-of-day. If, after you set the clock
(see “Setting the clock” section), the display
flashes, your electricity was off for a while. Reset
the clock.
• When showing the time of day, the display will
show the hour and minutes.
Electronic display
Clock
pad
(p. 10)
Increase
pad
(p. 10, 11)
Decrease
pad
(p. 10, 11)
• When you are using the timer, the display
will show seconds for time less than 1 minute,
minutes for time less than 1 hour, and hours
and minutes for time over 1 hour. The timer
indicator will be lit when in the timer mode.
PRESS YOU SEE
PRESS YOU SEE
PRESS YOU SEE