Filter
Top Products
Surface Burners
TYPICAL TOP BURNER RIME
Lift up the cooktop, following the instructions on pagel2.
Wipe off surface burners with warm soapy water and a soft cloth affer each
use.
Occasionally check surface burner flames for size and shape as shown. If
flames do not burn properly, you may need to remove the surface burners for
cleaning (see pageM), or call a qualified technician for burner adjustments.
To adjust the LO settings on the control knobs:
1.
Turn on the surface burners, then set the controls on LO.
2. Without changing the burner settings,
remove the control knobs.
3. Firmly grasp the control stem and insert a small bladed screwdriver into
the end of the stem. Turn the screwdriver in either direction until the flame
height isYe in (318 cm] or lower in size.
Flame must be large enough to
maintaln a STABLE FLAME on all burner ports.
NEVER ADJUST THE FLAME SIZE Al THE MEDIUM SEllING.
The Oven Door
Removing the oven door will make it easier to clean the oven.
Open the door to the first stop
position,
2. Hold the door at both sides and lift
off of hinges at bottom corners of
door.
3. To replace,
fit the bottom corners
of the door over the ends of the
hinges.
Push the door down evenly. The
door will close only when it is on
the hinges correctly.