Filter
Top Products
When the probe senses the
temperature you selected,
the oven shuts off. “End” will
show on the Display and 4
beeps will sound. (You can
stop the beeping by open-
ing the door or by touch-
ing CANCEL.) “End” will
remain on the Display and
a beep will sound every
30 seconds until the door
is opened or CANCEL is
touched. The Display will
then show the time of day.
NOTE: You can set Auto Set TEMP to follow COOK 1 or COOK 1 and 2. See
pages 14-17 for instructions. Auto Set TEMP can be programmed with the
Temperature Probe out, but the oven will pause between the last Cook cycle
and TEMP “PROB” will show on the Display to remind you to plug in the probe.
Changing the Pre-Programmed Setting
You can change the pre-programmed temperature and Cook Power in Auto
Set TEMP to the temperature and power you most often use. To change the
Auto Set TEMP setting, follow these steps:
1. Open the door.
2. Touch TEMP twice.
3. Touch the Number Pads for the new desired temperature between 90°F and
200°F If HIGH Cook Power is desired, skip to Step 6.
4. Touch COOK POWER.
5. Touch the Number Pad for the desired Cook Power.
6. Touch START. The oven will remember that temperature and Cook Power
for future use. NOTE: If the electric power goes off, the oven will go back
to the pre-programmed 169’F at HIGH Cook Power setting.
Additional Information
l
Temperature may be changed after START is touched by touching TEMP the
new number and START.
l
Cook Power may be changed after START is touched. Follow instructions on
page 14.
l
Auto Set TEMP will follow the last Cook cycle if programmed.
l
“PROB” will show on the Display after START is touched if the probe is not
plugged into the oven. This will only appear when Auto Set TEMP has been
selected alone, or between the last Cook cycle and Auto Set TEMP selection.
l
“ERR” will show on the Display after START is touched if an incorrect
temperature has been selected (under 90°F or over 200°F).
l
See “Hints for Using theTemperature Probe” on pages 27-29.