Filter
Top Products
Lighting Standing Pilots
To light Cooktop Pilots:
1.
Remove the grates and reflector
pans from cooktop. Remove the
cooktop. (See page 13.)
2. Make sure all controls are OFF.
3. To light,
hold a lit match over the
pilot light located between the
front and back burners. The pilot
flame should be ?‘A
t0
% in
(.635-.953 cm) high.
4. If the pilot flame needs adjust-
ment, turn the pilot adjustment
screw on the manifold pipe.
5. Replace the cooktop and replace
the grates before using the sur-
face burners.
To light Oven Burner Pilot:
1.
Make sure the Oven Temp control
knob is OFF.
2. Remove the broiler drawer.
Slide drawer out to stops, lift both
sides, then slide the rest of the
way out.
3. Hold a lit match overthe oven
burner pilot located at the rear
of the burner.
4. After the oven burner pilot is
burning steady, check burner
lighting by turning the Oven
Temp control knob to a tem-
perature abovel40”F (60°C). The
burner will take 5060 seconds
to light.
5. Replace the broiler drawer.