Filter
Top Products
l The ice maker will not operate until the
freezer is cold enough to make ice. This
can take overnight.
9 Because of new plumbing connections, the
first ice may be discolored or off-flavored.
Discard the first few batches of ice.
l If ice is not being made fast enough and
more ice is needed, turn the Refrigerator
Control toward a higher number. Wait a
day and, if necessary, turn the Freezer
Control toward C.
l If you remove the ice bin, raise the signal
arm to shut off the ice maker. When you
return the bin, push it in all the way and
lower the signal arm to the ON position.
l If cubes are stored too long, they may
develop an off-flavor . . . like stale water.
Throw them away. Ice maker will make
new ice. Cubes in the ice bin can also
become smaller by evaporation.
l Good water quality is important for good
ice quality. It is not recommended that the
ice maker be connected to a softened
water supply. Water softener chemicals,
such as salt from a malfunctioning soft-
ener, can damage the ice maker moM and
lead to poor ice quality. If a softened water
supply cannot be avoided, it is important
that the water softener be well maintained
and operating properly.
Changing the light bulbs
Electrical Shock Hazard
Before removing a light bulb, either
unplug the refrigerator or disconnect
the electricity leading to the refrigerator
at the main power supply.
Failure to do so could result in electri-
cal shock or personal injury.
To change the refrigerator light:
1. Disconnect refrigerator from power
supply.
2. Reach behind Control Panel to remove
bulbs.
3. Remove bulb and replace with a 40-watt
appliance bulb.
4. Reconnect refrigerator to power supply.
NOTE: Not all commercial appliance bulbs
will fit your refrigerator. Be sure to replace a
bulb with one of the same size and shape.
11