Filter
Top Products
Removing the base grille
To remove the grille:
1. Open refrigerator door.
2. Pull base grille forward to release the
Condenser
support tabs from the metal clips.
3. Do not remove Tech Sheet fastened
behind the grille.
To replace the grille:
1. Line up grille support tabs with metal
clips.
2. Push firmly to snap into place.
3. Close refrigerator door.
See cleaning instructions for defrost pan and
condenser coils on page 15.
Reversing the door swing
You can change the hinges on your refrig-
erator so the doors open the other way.
Refer to the instruction sheet included with
your refrioerator.
Understanding the sounds you may hear
Your new refrigerator may make sounds
that your old one didn’t. Because the
sounds are new to you, you might be
concerned about them. Don’t be. Most of
the new sounds are normal. Hard surfaces
like the floor, walls and cabinets can make
the sounds seem louder.
The following describes the kinds of
sounds that might be new to you, and what
may be making them.
Slight hum, soft hiss
You may hear the refrigerator’s fan motor
and moving air.
Clicking or snapping sounds
The thermostat makes a definite click when
the refrigerator stops running. It also makes
a sound when the refrigerator starts. The
defrost timer will click when the defrost cycle
starts.
Water sounds
When the refrigerator stops running, you
may hear gurgling in the tubing for a few
minutes after it stops. You may also hear
defrost water running into the defrost water
pan.
Ice maker sounds
l trickling water
l thud (clatter of ice)
If your refrigerator has an ice maker, you
may hear buzzing (from the water valve),
trickling water and the clatter of ice dumped
into the bin.
Running sounds
Your refrigerator has a high-efficiency
compressor and motor. It will run longer than
older designs. It may even seem to run most
of the time.
12