Filter
Top Products
14
If the door closes too quickly, decrease the spring
tension by moving the spring end toward the front of
the dishwasher.
NOTE: Springs should be in the same notches on left
and right sides.
Closes too quickly—
Decrease spring tension
5
If the door falls open, increase the spring tension by
moving the spring end toward the back of the
dishwasher.
NOTE: Springs should be in the same notches on left
and right sides.
Door falls open—
Increase spring tension
6
IMPORTANT: If wheels were removed, protect the floor
when moving the dishwasher. Slowly move dishwasher
completely into cabinet opening. Do not kink or pinch
water line, drain hose, power supply cord or direct wire
between dishwasher and cabinet. Remove cardboard
from under dishwasher.
NOTE: It is all right if dishwasher fits tightly into cabinet
opening. Do not remove insulation blanket – the blanket
reduces the sound level.
NOTE: If using power cord, make sure to route end
through hole in cutout before sliding into cabinet opening.
Move dishwasher into
cabinet opening
7
Insulation
blanket
Insulation
blanket
Align front of dishwasher door panel with front of
cabinet doors. You may need to adjust alignment to be
even with your cabinets.
Align front of dishwasher
with front of cabinet doors
8
9
Check for plumb and
adjust legs if needed
Check that leveling legs are firmly against the floor.
Close and latch the door, and place level against the
front panel. Check that dishwasher is centered from front
to back in the opening. If needed, adjust leveling leg until
dishwasher is plumb. Repeat for other side of dishwasher.