Filter
Top Products
Operating Instructions
Continued
Starting your dishwasher
Select a drying option. (Use Air Dry for Rinse
& Hold Cycle.) HEAT DRY is automatically
selected with the Pots & Pans Cycle. The indi-
cator above the button will show white when
that option has been selected.
If the Pots 8 Pans Cycle will be used, push the
POTS & PANS button until the indicator above
the button shows white. If the Normal Wash,
Light Wash or Rinse 8 Hold Cycles will be used,
push the POTS & PANS button until the indica-
tor above the button shows black.
3. Turn the Cycle Control Knob clockwise to point
to a desired cycle. You will feel a definite stop at
each cycle mark. The dishwasher will automati-
cally start that cycle.
NOTE: If the door is latched, you will hear cycles
start and stop as the knob passes each cycle
mark. This is normal and will not hurt the dish-
washer. If you prefer, you can set cycles with the
door unlatched.
To add a dish after starting
1. To be sure the added item is washed and
rinsed, make sure the Cycle Control Knob has
not passed LIGHT WASH.
2. Lift up on the door latch to unlatch door and
stop the cycle.
3. Open the door and add the dish.
4. Close the door. Do not latch it. Wait 30
seconds for air in the dishwasher to warm up.
This helps reduce the amount of moisture
that can come from the vent when restarting
the cycle.
5. Press door in to latch it. The dishwasher will
start where it stopped.
Changing a cycle setting
You can change a setting anytime during
any cycle.
1. Lift up on the door latch to unlatch the door
and stop the cycle.
2. Turn the Cycle Control Knob clockwise to the
cycle you want.
3. Be sure the detergent dispensers are filled
properly for the new cycle. When changing dial
from LIGHT WASH to NORMAL WASH or
POTS & PANS setting, detergent is released.
Reload covered section of dispenser before
starting Normal Wash Cycle or Pots & Pans
Cycle.
4. Close and latch the door. The dishwasher will
automatically start the new cycle.