Filter
Top Products
Common Dishwashing Problems
PROBLEM
CAUSED BY
Spotting and filming
Hard water
SOLUTION
Fill detergent dispensers to
capacity. Use dishwasher
detergent with highest available
phosphorus content. May be
necessary to install water
softener.
To remove spots and film, try a
vinegar rinse . . .
1. Wash and rinse load as usual.
Use the Energy Saver Dry
Option.
2. Remove all metal items.
3. Put 2 cups (500 mL) white
vinegar in a container on the
bottom rack.
4. Run dishwasher through a
complete washing cycle.
Water is not hot enough
Water temperature should be at
least 140°F (SOT). Set water heater
thermostat to a higher setting. Run
water at sink until hot before
starting.
Not enough detergent, or improper
detergent
Use more dishwasher detergent.
Use detergent with highest
available phosphorus content . . .
especially with hard water.
“Old” detergent
Improper loading
No rinse agent
Use only fresh dishwasher
detergent. Store tightly closed
container in cool. dry place. Discard
old detergent. Do not fill dispensers
until ready to start dishwasher.
Make sure dishes and glassware
are loaded so spray reaches all
surfaces and items dram properly.
Do not overload. Do not nest items.
Make sure large items do not block
spray from reaching detergent
dispensers.
Does the rinse agent dispenser need
filling? See instructions on page 8.
Drying with Energy Saver Option Drying without heat may result in
some spotting of glasses and silver.
Dry with heat.
Small particles deposited on
items
Spray arm not rotating freely
Check spray arm to make sure it
turns freely after loading. Be sure a
utensil has not prevented it from
turning.
Page 10